Used to program remotes with the Remote programming special function. After done dash restart and km appears again.įinally: Keys programmed, working well, starts the car. This value need to set 6 then press “Change”. After read it shows the eeprom content, km, skc, and immo status also!Īt immo status this time is 0. Need to put it to adapted mode.Ĭhoose Instument K-Line -> since this car had R8 crypto+ dask, choose this type at the top rolldown list. This state is almost the same as at the begining, car wont start. L7 means immo status 7 -> key programming, x means actual key number, y means total number of keys.Īfter all keys programmed, should see L0 x-x where x the number of keys. During whole procedure, dash should show L7 x-y. The program follows the whole learning procedure, well commented with message boxes, ask step-by-step key->igniton->nextkey->ignition. Function detect the vehicle, then automaticaly select the proper lines, just need click Next button. So now got prepared transponder, and dash in boot mode -> I used wizzard mode of key learning. 3-3 means 3/3 key learn, L0 is the immobilizer status… half an hour googling and already know whats happening. ( This moment a bit paniced, since dash says L0 3-3 insted of km, and car not able to start with any key. Need prepare the transponder with this function, actually read details from immobilizer to prepare the transponder for the car, and also send the Dash to BOOT mode with virginized key slots. To learn new key, need to prepare a VIRGIN Megamos ID48 transponder after Auto detect the pin.Īfter PIN appears, also appear a button : Prepare Dealer key.

Getting the SKC -> Simple job, Key learning -> Ignition ON -> Auto detect. One user experience published on 6th-August-2018: Procedure ask ignition off, than ignition on, done.Ĭar fires up with new key, after remote also work! Key learning: select Opel / Astra H > Connect immo > read fine, insert new key, Select next empty position, then Program transponder and remote and write pin.

Special functions: Read pin > select Opel / Astra H / Info display : reads correct pin Result: OK, done quickly, first car cranks only then stop, 2nd start car fires up! Solution: FVDI BMW – Special functions, Sync DME-CAS One user experience published on 21th-September-2018:

Who is right and who is fake? Now it is no longer clear.įVDI 2018 Feedback on what work and don’t work, thanks the users’ newest experience. Lots of functions of the newer software versions dont’work properly but it still can be worth the money depending on which (working) functions you need….Ī: “flyfvdi” does not have the device “FVDI 2018” while “flyobd” has.įlyobd (STIC technology co., LTD) is the original factory of FVDI 2018 unlock version. It works as crappy as FVDI 2015, just adds some VVDI2 functions.

Fvdi 2018 feedback